Mooring Lines for Catamarans: Selection, Sizing and Configuration
A catamaran doesn’t sit in a slip like a monohull—it has two hulls fighting the wind, a wide beam that changes line angles, and a bridle setup that can double the load on a single cleat if you get it wrong.
TL;DR: Catamarans need mooring lines sized by displacement, not just length, and the wide beam changes everything about how loads distribute. Jimmy Green Marine’s guidance is blunt: if your boat is a multihull, move up to the next size column when selecting bridle and mooring line diameters . For a typical 40-foot catamaran displacing around 9 tonnes, that means 24mm nylon rather than the 20mm a monohull of the same length might use . For mooring to a buoy or anchor, a bridle spreads the load between two hull attachment points—but on a cat, the wider bridle angle means each leg can end up taking the full load for substantial periods . For docking, you need at least four lines, and spring lines matter more than most cat owners realize.
Key Takeaways
- Size by displacement, not length. A catamaran is heavier than a monohull of the same LOA, and the beam changes line geometry .
- Jimmy Green’s multihull rule: move up one size column from the monohull chart .
- For a 40-foot cat around 9 tonnes, that’s roughly 24mm nylon for a bridle or permanent mooring strop .
- A mooring bridle spreads load between two bow attachment points, but the wide angle on a cat means each leg must be sized to take the full load alone .
- Safety reminder: Don’t rely on bow rollers or stanchions as primary mooring points. Use properly backed cleats or dedicated through-bolted attachment points .
Sizing: Why Displacement Beats Length for Catamarans
The standard mooring line charts are built for monohulls. Catamarans break those charts.
Jimmy Green Marine’s bridle selection guide is explicit: “If the displacement is greater than displayed in your column in the table, or your yacht is a multihull, consider moving across to the next column to increase the diameter” .
Here’s what that looks like in practice using their table :
| Boat Length Overall | Monohull Displacement Reference | Strop Diameter (Standard) | Multihull Approach |
|---|---|---|---|
| 8–10 m (26–33 ft) | 5 tonnes | 20mm | Consider 24mm |
| 10–12 m (33–40 ft) | 9 tonnes | 24mm | Consider 28mm |
| 12–14 m (40–46 ft) | 13 tonnes | 28mm | Consider 32mm |
A 40-foot catamaran often displaces 8–12 tonnes depending on construction and load. That puts it in a column where a monohull of the same length might weigh 6–7 tonnes. The extra mass means more kinetic energy when the boat surges, and more load on the lines.
The beam matters too. A cat’s wide stance means lines run at different angles than on a monohull, and those angles change how efficiently each line resists load.
The Bridle: Load Sharing That Isn’t Always Shared
For mooring to a buoy or anchor, a bridle is standard on catamarans. Two legs run from the buoy or chain back to attachment points on each hull, spreading the load.
But Jimmy Green Marine’s advisory contains a warning most cat owners miss: “Due to the wider bridle angle resulting from a broader beam, each tail on a multihull setup will take the entire load for a substantial proportion of the time at anchor or on a mooring” .
In other words, the bridle looks like it’s sharing load, but as the boat swings, one leg takes everything while the other goes slack. Then they swap. Each leg needs to be strong enough to handle the full load alone.
“Separate hardware-connected lines may therefore be required for catamarans and trimarans” .
If your bridle legs aren’t independently rated for the full load, you don’t have redundancy—you have two lines that each hope the other one is working.
For owners without bow cleats, a Cruisers Forum discussion describes using the anchor bridle attachment shackles on the crossbeam, running lines through the mooring apparatus, and securing back to a windlass or cleat—but cautions against loading bow rollers and stanchions .
Docking Configuration: Four Lines Minimum, Springs Are Critical
Docking a catamaran is a different dance than docking a monohull.
Cruising Sea’s beginner guide recommends at least four dock lines—two bow and two stern—set at roughly 45-degree angles to the dock . That’s the baseline for a calm slip.
But catamarans catch wind like a sail. The high freeboard and wide beam mean more windage area, and the twin hulls can make the boat hunt in its slip. Spring lines become essential, not optional. Without them, the boat surges forward and back against the bow and stern lines, and those lines take loads they weren’t angled to handle efficiently.
The practical setup for a cat in a slip: bow lines to port and starboard, stern lines to port and starboard, and at least one spring line running forward and one running aft. If your slip is exposed, double the springs.
For shore ties in anchorages where swinging isn’t viable, Cruisers Forum discussions suggest long lines—50 to 100 meters—in floating materials like polypropylene or UHMWPE, with serious chafe protection for rocks . A 52-foot, 15-tonne cat owner was considering 16–18mm lines with 3,400–4,000 kg breaking strength .
FAQ
What size mooring lines does a catamaran need?
Size by displacement and move up one size from monohull charts. A 40-foot cat around 9 tonnes typically needs 24mm nylon, while a heavier or more exposed cat might step up to 28mm .
Why does a catamaran bridle need stronger legs than a monohull bridle?
The wider beam creates a wider bridle angle. As the boat swings, one leg takes the full load while the other goes slack, then they swap. Each leg must be rated for the full load alone .
Can I use my anchor bridle attachment points for mooring lines?
You can, and some cat owners do, but check the hardware and backing. Through-bolted shackles designed for anchor loads are typically robust, but avoid loading stanchions or bow rollers as primary mooring points .
How many dock lines should a catamaran use?
At minimum, four: two bow and two stern. For exposed slips or storm conditions, add spring lines and double up where possible. Spring lines are especially important because the cat’s windage makes it hunt in the slip .
What material is best for catamaran mooring lines?
Nylon is the standard for shock absorption. Polyester is better for permanent moorings where UV resistance and low stretch matter. Polypropylene floats and is useful for shore ties but has lower strength and UV resistance .
Do catamarans need special chafe protection?
Yes, and more of it. The wide beam and twin hulls create more contact points, and cats often sit in exposed moorings where they swing and surge. Chafe guards at cleats, fairleads, and bridle attachment points are not optional .
References
- Jimmy Green Marine — Mooring Bridles: multihull sizing guidance, bridle load distribution warning. https://jimmygreen.com/1012-mooring-bridles
- Jimmy Green Marine — Mooring Warps and Mooring Lines: material comparison, stretch and strength data. https://jimmygreen.com/84-mooring-warps-and-mooring-lines
- Cruisers Forum — Adjustable mooring bridle on a catamaran with no bow cleat: practical attachment solutions. https://www.cruisersforum.com/forums/f118/adjustable-mooring-bridle-on-a-catamaran-with-no-bow-cleat-290227.html
- Cruisers Forum — Hurricane Plan: Dock Lines: multihull line sizing discussion, cleat limitations. https://www.cruisersforum.com/forums/f90/hurricane-plan-dock-lines-202833.html
- Cruisers Forum — Shore tie lines for 52ft catamaran: long line shore tie discussion. https://www.cruisersforum.com/forums/printthread.php?t=286487&pp=15
- Cruising Sea — How to Dock and Undock a Catamaran: four-line minimum, 45-degree angle guidance. https://cruisingsea.com/how-to-dock-and-undock-a-catamaran-a-beginners-guide/
- Pirates Cave Chandlery — What Size Mooring Rope Do I Need: material behaviour, chafe protection, cleat backing guidance. https://www.piratescave.co.uk/blog/what-size-mooring-rope-do-i-need/
- CommsWiki — Mooring Line Size Guide: general diameter guidelines, safety factor, inspection intervals. https://commswiki.lbbnrd.org/mooring-line-size-guide/
What’s your catamaran mooring setup—bridle to a buoy, four lines in a slip, or something more elaborate? Drop a comment below with what’s worked (or failed) on your boat.